E&J 73.6V Lithium Iron Phosphate (LiFePO4) Segway replacement battery for Segway X2 I2 PT series ducts
Compatibility
All I2 and X2 Segway PT models ( that were shipped from the factory after Oct 12th, 2006) are compatible with the Li-Ion batteries. Segway PT software version 14.0 or later is required for Li-ion batteries. If you own a Segway PT model I180, XT, or GT, you already have version 14.0 software or higher and your Li-ion batteries are ” plug and play”. An upgrade to the Segway PT software is necessary in order to use Li-ion batteries with older Segway PT models (Li-ion batteries are not compatible with P series models). To identify the software version on your I67, I170, I180, or E167 PT, first, power on, then power down while observing the display.
Replace Batteries in Pairs.
Whenever you replace a Battery, consider replacing both batteries. Replacing only one battery will not necessarily increase the performance or range of your Segway PT, because the Segway PT is designed to operate only at the level allowed by the lower-energy battery. Redundancy is a critical safety feature built into the Segway PT. This applies to the batteries. Therefore, you should replace battery in pairs (except in the unusual situation where a battery is replaced because of damage or defect and the other battery is relatively new).
Model | EJ-LFPSW72V 5.6Ah |
Dimension | 355*188*82mm |
Voltage | 73.6V |
Capacity | 5.6Ah |
Impedance | <12m ohm |
Discharge cut-off voltage | 65V |
Maximum Charge voltage | 80V |
Standard charge current | 2.5C |
Max working current | 5C |
Charging and charger | CC/CV with professional charger |
Weight | <6Kg |
Working temperature | Charge:0-60 degree |
Discharge: -20-55 degree | |
Storage temperature | minus 20 – 55 degree |
Type | electric motorcar battery 72V 5.6Ah LiFePo4 battery |
Cycle life | 1500 cycles with DOD 100% to 80% capacity under normal temperature. 2000 times cycle life. |
Dimensional specification
Battery analyzer for Segway X2 I2 monitor 23S battery cell voltage SOC